Adjusting The Legs; Disposing Of The Packaging; Disposing Of Your Old Refrigerator; Placing And Installation - Beko TS190030N Manuel D'utilisation

Disposing of the packaging

The packing materials may be dangerous
for children. Keep the packing materials
out of the reach of children or dispose of
them by classifying them in accordance
with the waste instructions stated by
your local authorities. Do not throw away
with regular house waste, throw away on
packaging pick up spots designated by the
local authorities.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
You may consult your authorized dealer
or waste collection center of your
municipality about the disposal of your
refrigerator.
Before disposing of your refrigerator, cut
out the electric plug and, if there are any
locks on the door, make them inoperable
in order to protect children against any
danger.

Placing and Installation

A
If the entrance door of the room where
the refrigerator will be installed is not wide
enough for the refrigerator to pass through,
then call the authorized service to have
them remove the doors of your refrigerator
and pass it sideways through the door.
1.
Install your refrigerator to a place
that allows ease of use.
2.
Keep your refrigerator away from
heat sources, humid places and direct
sunlight.
3.
There must be appropriate air
ventilation around your refrigerator in
order to achieve an efficient operation. If
the refrigerator is to be placed in a recess
in the wall, there must be at least 5 cm
distance with the ceiling and at least 5 cm
with the wall. Do not place your product on
the materials such as rug or carpet.
4.
Place your refrigerator on an even
floor surface to prevent jolts.
5.
Your product requires adequate
air circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling,
rear wall and the side walls.If the product
will be placed in an alcove, remember to
leave at least 5 cm clearance between the
product and the ceiling, rear wall and the
side walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product). If the
component is not available, or if it is lost
or fallen, position the product so that at
least 5 cm clearance shall be left between
the rear surface of the product and the
wall of the room. The clearance at the rear
is important for efficient operation of the
product.

Adjusting the legs

If your refrigerator is unbalanced;
You can balance your refrigerator by
turning its front legs as illustrated in the
figure. The corner where the leg exists is
lowered when you turn in the direction of
black arrow and raised when you turn in
the opposite direction. Taking help from
someone to slightly lift the refrigerator will
facilitate this process.
12
EN