Frequently Asked Questions; Emptying The Machine - STARBUCKS Verismo 580 K-fee Manuel D'utilisation

Frequently asked
EN
questions
Designed for beverage pods that bear the
Verismo™ System logo. Also compatible
with other K-fee® System pods.
Emptying the
EN
machine
12
Why is there a delay before the drink is dispensed?
The machine is adjusting to the right temperature to make your beverage.
After using the milk pod, why isn't the drink dispensing immediately after pressing the Espresso or Brewed buttons?
After a milk pod, the machine requires 8–10 seconds to heat to the required temperature. Push Espresso (top) button. Wait until lights stop
blinking, then push Espresso (top) button again.
How do I remove the pod container if it is jammed or overfilled?
Gently move the pod container back and forth while removing the container.
Why isn't the beverage hot enough?
The machine may need to be descaled (refer to section "Descaling the Machine").
Why are all the buttons flashing at a fast rate for a prolonged period of time?
Try switching off the machine and unplugging the cord from the wall socket. If this problem persists, please visit Verismo.com.
Why isn't the drink dispensing properly?
Ensure the lever is pressed down completely. If necessary, descale the machine (refer to section "Descaling the Machine").
Does the machine switch itself off suddenly when it is used a lot?
The machine switches itself off as protection against overheating. If this occurs, let the machine cool down for about 30 minutes before using
it again.
If any problems persist, contact Verismo.com
Empty the residual water if the appliance should be transported or stored during frosty conditions (temperatures below 32°F / 0°C). This
prevents residual water from freezing inside the appliance.
Let appliance warm up to room temperature if necessary. Make sure that the appliance is switched off. Open lever and close it again. Remove
and empty the water tank. Press the Espresso and Milk buttons at the same time, hold them and press the Power button for at least three
seconds. Evaporation will start. Wait until evaporation is finished. Reinsert emtpy water tank. Wipe and dry the front of the appliance with
a cloth.
WARNING
WARNING: Extremely hot water
The steam temperature can be as high as 248°F / 120°C. Do not reach under the spout and keep at a distance from spout.
WARNING: Extreme temperatures
• Protect the appliance against frost.
• Do not operate the appliance above 115°F / 45°C to avoid risks to the appliance (temperature range for operation is 50–115°F / 10–45°C).
• Do not operate the appliance below 50°F / 10°C to avoid risks to the appliance (temperature range for operation is 50–115°F / 10–45°C).