Changing Lemo Connector - FujiFilm FUJINON Premista28-100mmT2.9 F/M Mode D'emploi

7.2 Changing LEMO Connector

If you do not use the LEMO Connector, replace it with the Cover for LEMO Connector supplied with this
product.
Use the following procedure to replace the LEMO Connector with the Cover for LEMO Connector:
a. Remove the four LEMO Connector installation screws ().
b. Remove the LEMO Connector () from the Lens main body.
Note . When you remove the LEMO Connector, be sure not to touch the internal printed circuit board
and switches. Otherwise, it may cause trouble, such as a communication failure. If the setting of a
switch is accidentally changed, contact the service center of our company.
c. Attach the Cover for LEMO Connector (supplied with this product) in the location where the LEMO
Connector () was attached. Firmly fix the Cover using the four LEMO Connector installation screws ()
that were removed in step a.
Note . After you remove the LEMO Connector installation screws (), keep them in a safe place because
they are required to attach the LEMO Connector. If the screws are lost, use the spare screws
supplied with this product.
Cover for LEMO connector
①
①
MEMO
- 8 -
②