Denon BU5501 Manuel De L'utilisateur page 6

ENGLISH
We greatly appreciate your purchase of this product.
The BU5501 CD Drive & Mounting Kit is designed specifically for
mounting to the DN-HS5500 Professional Media & Controller.
Accessories
Check that the following parts supplied with the product.
q
Owner's Manual ...................................................................... 1
w
CD Drive & Mounting Kit ......................................................... 1
e
Screws (M3 x 6 mm, Black) .................................................... 2
r
Hex. Head Screws (M3 x 6 mm) ............................................. 4
t
Plate ........................................................................................ 1
y
Front panel .............................................................................. 1
u
Hex. wrench ............................................................................ 1
i
Service Station List .................................................................. 1
o
Service Station List (For Japan only) ....................................... 1
NOTE
Be sure to download the firmware from the website shown below and
update the product's firmware version.
www.denondj.com
The functions describe in these handling instructions will not operate
unless the firmware is updated.
Mounting Procedure
1. Turn the DN-HS5500's power switch off and unplug the power
cord from the power outlet.
2.
Remove the four screws (hexagonal head screws) fastening the
DN-HS5500's front panel, then remove the front panel.
3.
Remove the two screws fastening the plate under where the front
panel was mounted, then remove the plate.
4.
Holding the mount section of the mounting kit, insert the mounting
kit's metal sheet into the hollow in the rail in the DN-HS5500's
opening and push inside.
5.
Fix the included plate to the DN-HS5500 together with the mounting
kit using the two included screws (M3 x 6 mm), as shown on the
diagram.
6.
Mount the included front panel to the DN-HS5500 using the four
screws (M3 x 6 mm hexagonal head screws) included with the DN-
HS5500.
The CD drive is now mounted on the DN-HS5500 and will operate.
Handle the set in which the CD drive is installed with sufficient care.
Refer to this manual for instructions on operating the CD, to the DN-
HS5500's manual for instructions on other operations.
NOTE
• When handling the CD Drive & Mounting Kit, hold the metallic part
at the tip and do not touch the circuit boards or terminals.
Doing so could damage the set.
• CD drives can easily be damaged by shocks. When handling the CD
drive, be very careful not to drop it, etc.
• When the DN-HS5500's front panel is removed, do not put your
fingers or other objects into the set through the opening. Doing so
could damage the set.