Publicité
Les langues disponibles
Les langues disponibles
OPeraTiON
(cONTiNUeD)
• To set the thermostat, press the Temp Set button until Desired Temperature is reached. Note: the Desired
Temperature will flash three times and then Current Temperature in the room will display as a steady red.
• To constantly run the heater without a thermostat setting, press the Temp Set button until Hi is
displayed in Temperature Display. In this mode, make sure to manually shut the heater OFF when
done using this appliance.
• To set the Timer, press the (
that chosen period in the selected mode, counting down the remaining time in the display bar and
automatically shut off after the desired time has passed.
remote control
The Digital 360° Surround Heater can be completely controlled with the remote. Two AAA 1.5V batteries are
required (included). To install batteries:
• Remove the cover located on the back of the remote control.
• Insert two AAA 1.5V batteries, positioning them correctly (see instructions in the batteries compartment).
• Replace the cover.
remote control Operation
• Locate remote control packed in the top insert.
• Press (
) to turn heater on or off.
• Press (
) to choose LO (900W) or HI (1500W) Heat Level Setting.
• Press (
) to choose 1, 2, 4 or 8 hour setting.
• Press SET to choose a thermostat setting. Desired Temperature
will flash three times and then Current Temperature in the room
will display as a steady red.
• Replace remote control in the holder on the side of the heater
when not in use.
SaFeTY FeaTUreS
The 360º Ceramic Surround Heater is equipped with several devices and features for added protection:
• 360° SafetyTIP™ is an all-around tip-over switch that disables the heater if it is accidentally tipped
in any direction.
• A high temperature safety control prevents overheating.
• This heater is also equipped with a thermal cut-off fuse that will permanently shut down the heater
should it operate at a higher than normal temperature.
• This heater was created using a high quality safety plastic.
cLeaNiNG aND STOraGe
We recommend that the 360º Ceramic Surround Heater be cleaned at least once a month and before
off-season storage.
• Turn the heater OFF (
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES,
POLISHES OR ANY CHEMICAL SOLUTION.
• Before storing, clean the 360º Ceramic Surround Heater using the above-mentioned steps. Wrap the
cord around the unit. Place in its original box and store it in a cool, dry place.
• This heater does not disassemble.
6
) button to select 1, 2, 4, or 8 hour setting. The heater will run for
) or (
) and unplug it. Allow it to cool.
model HZ-440 remote
Power
Button
Heat
Temperature
Level
Set Button
Setting
Timer
Publicité
