Use - DS Produkte 03444 Mode D'emploi

EN
Control Panel
By pressing the buttons on the control panel, the following functions can be chosen:
10
9

Use

PLEASE NOTE!
■ Do not use the device in bed. Do not fall asleep while using the device.
■ The device must not be folded up or covered when it is switched on. Do not place the
mains cable on or beneath the device during operation.
1. Place the massage seat cushion on a chair, for example.
2. Place the fastening elastic bands around the backrest and seat surface and fi x them
in place with the Velcro fasteners so that the seat cushion does not slip.
3. Connect the coaxial connector of the mains adapter or car adapter to the connecting
socket on the device and plug the mains adapter into an easily accessible plug socket
or plug the car adapter into the cigarette lighter.
4. Sit on the massage seat cushion and lean back.
5. Press the
6. Press the
7. Press the
8. Press the
9. After 15 minutes the device automatically switches off. It can also be switched off at
any time by pressing the
10. Pull the mains adapter out of the plug socket or pull the car adapter out of the ciga-
rette lighter.
11. Disconnect the mains cable of the mains adapter or the car adapter from the device.
12. Allow the device to cool down if the heating function was activated before it is stored
away or cleaned (see the "Cleaning and Storage" chapter).
7 Switch the heat on and off
8 Switch the device on and off
7 9 Select the massage programme. The device has
4 different massage programmes.
After 15 minutes the device automatically switches off.
10 HEAT Control lamp: lights up when heat is switched on.
8
button to switch on the device. The device starts to massage.
button to switch between the different massage programmes.
button to add heat. The HEAT control lamp lights up.
button again to switch off the heat. The HEAT control lamp goes out.
button.
16