Resus Risycor NV Manuel page 36

8. Secure this position using the supplied tie wrap. Write the date of
installation on the label of this tie wrap. Securing with, for example,
a nut and bolt or padlock is also possible (using the appropriate
holes).
9. Refill the installation (or the corresponding part) with water. Then
set everything to the correct pressure.
■ 7 ACTIVATION
CAUTION! The activation of the corrosion monitor should be carried
out:
• In a new installation: before the first filling / flushing with water;
• In an existing installation: during the installation process.
1. Plug in the mains adaptor into the nearest electrical outlet and
connect the logger to the power supply. Provide strain relief for the
cable of the AC adaptor, possibly by using the supplied tie wrap.
NOTE:
too short, an extension cord can be used to connect the mains
36
If no power outlet is available, or if the power cable is