Omnitronic CDT-150 Mode D'emploi page 19

5. CUE-LED
6. CUE-BUTTON
If you press the Cue-button during playback, the player returns to the track-start or the Cue-point and goes
into Pause-mode. Please refer to the explanations under 6.7 Cueing.
7. PLAY/PAUSE LED
8. PLAY/PAUSE-BUTTON
With the Play/Pause-button, you can start the playback and stop it again. Please refer to the explanations
under 6.4 Play/Pause.
9. LOOP IN -LED
10. LOOP IN-BUTTON
By pressing the In-button, you can memorize the Cue-point. Additionally, you can set the starting point of the
sequence with the In-button. Please refer to the explanations under 6.8 Memorizing a sequence (Loop-
function).
11. LOOP OUT/RELOOP-BUTTON
Press the Loop Out-button to set the end point of the sequence. Now, the CD-player repeats the sequence
between the two points until you press the Loop Out-button to exit the loop-function. Press the Loop
Out/Reloop-button once again to resume the sequence from point A again.
12. / 13. SEARCH-BUTTONS
Pause-mode:
To cue and reverse at a very low speed. You can exactly select the starting-point. The selected frame is
repeated if you have pressed the Cue-button before (CUE-LED lights up).
Playback-mode:
Use the Search/Scan-buttons in order to cue and reverse at a very high speed.
14. / 15. TRACK-BUTTONS
Via the Track-buttons, you can select the desired track. Please refer to the explanations under 6.5 Selecting
a track via the Track-buttons.
16. LOOP OUT-LED
17. TIME-BUTTON
By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed) or total remain time (Total Remain).
18. PITCH BEND-BUTTONS
With the Pitch Bend-buttons, you can adjust the playback-speed temporarily by +/- 16 e.g. to synchronize the
bass-beat of two different signal-sources. Please refer to 6.6 Adjusting the playback-speed.
19. PITCHFADER
You can adjust the desired speed with the Pitchfader after pressing the Pitch-button. The display shows the
current percentage. If the Pitch-button is not pressed, the adjustment on the Pitchfader will have no effect.
20. 8/12/16 PITCH RANGE-BUTTON
You can select the speed-adjusting range between ±8, 12 and 16 % by pressing the Pitch Range-button.
21. PITCH-BUTTON
With this button, you can switch the speed-adjustment via the pitchfader on and off. Please refer to 6.6
Adjusting the playback-speed.
22. PITCH RANGE-LED
23. PITCH ON/OFF-LED
19/44 10602277_V_1_0.DOC