Hama uRage SoundZbar 2.1 Unleashed Mode D'emploi page 4

R
isk of electric shock
• Do not open the device or continue to operate it if
it becomes damaged.
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to qualified
experts.
5. Startup and Operation
Note
• The product is mains or battery operated. For mains
operation, you merely have to connect the product
to the mains supply (see Section 4.2). For battery
operation, the product must first be fully charged
(see Section 13).
Warning
• Connect the product only to a socket that has
been approved for the device. The socket must be
installed close to the product and must be easily
accessible.
• Disconnect the product from the network using the
power button – if this is not available, unplug the
power cord from the socket.
• The electrical socket must always be easily
accessible.
• If you will not be using the product for a long
period of time, disconnect it from mains power.
• Connect the power cables of the SoundZbar and the
subwoofer to properly installed power sockets.
• Press [POWER] (1) to switch on the SoundZbar.
• Press the on/off switch (1) to switch on the subwoofer.
• The connection status LED (3) on the subwoofer
begins to flash blue.
Note – Turning the radio on for the first time
• The SoundZbar and subwoofer, once switched
on, will automatically connect to one another via
Bluetooth.
• After successful connection, the connection status
LED (3) on the subwoofer is constantly lit blue.
6. Bluetooth pairing
You can pair your terminal device with the SoundZbar
via Bluetooth and use the SoundZbar as a playback
device for audio signals.
Note – Bluetooth
• Check whether your mobile device (smartphone,
tablet PC. etc.) is Bluetooth capable.
• Note that the maximum range for Bluetooth is 10
metres without obstacles such as walls, people,
etc.
• The Bluetooth connection may be disrupted by
other Bluetooth devices/ connections in the vicinity.
• It is only possible to connect the SoundZbar to one
terminal device.
• Note that compatibility depends on the supported
Bluetooth profiles as well as the Bluetooth versions
being used. (see Technical Data, operating
instructions of the terminal device in use)
• Make sure that your Bluetooth capable terminal
device is on and Bluetooth is activated.
• Activate the Bluetooth mode by repeatedly pressing
[SOURCE] (2) on the SoundZbar.
• The status LED for the Bluetooth connection (10)
begins to flash blue.
• Open the Bluetooth settings on your terminal device
and wait until uRage SoundZbar appears in the list of
Bluetooth devices found.
• Select the uRage SoundZbar in the list of available
devices and wait until the SoundZbar is shown as
connected in the Bluetooth settings on your terminal
device. The status LED for the Bluetooth connection
(10) is now constantly lit blue.
• Start and control audio playback using the controls of
the terminal device.
®
7