Enabling The Auxiliary Output (Aux) - Fermax cityline MEMOKEY Manuel D'installation Et Utilisation

Enabling the Auxiliary Output (all-purpose device) - AUX (A8)
This equipment has a free contact auxiliary output which can be connected to a 6 Vdc device
with a maximum current of 300 mA to carry out various functions.
Where the equipment to be connected does not adjust to these specifications, a relay
should be used (Ref. 2013).
1 Enter programming mode:
2 Enter the relevant option:
3 Select the option you require:
0: The all purpose output is not used (by default). The auxiliary
output remains deactivated.
1: Each time a valid code is entered a 1 second pulse will be
generated.
2: Every time Relay 1 is activated the all-purpose device will also
activate, and will remain activated for 5 seconds longer than
the associated device.
3: The all purpose output will switch every time a valid code is
entered.
4: The all purpose output will be activated and will remain active
every time you press "A" and a valid keypad code, (purpose
output will remain during 1 minute active).
5: The all purpose output activates once 3 erroneous codes are
entered in order, and will remain active for 5 minutes or until a
valid code is entered.
6: The all purpose output activates once any key is pressed or
deactivates after 15 seconds with inactivity.
Example:
Enable auxiliary output
Master Code (1480)
A8
1480 A8 1
beep (x3)
beep (x3)
beep (x3)
Page 11