BOMANN KA 157 CB Mode D'emploi & Garantie page 31

• Insert the plug in a duly installed 230V/50Hz protective contact socket. The
details can be found on the appliance's nameplate.
• Make sure that the appliance is switched off. (The light in the on/off switch is
off).
1. Pull the lid of the water tank forwards. Fill the machine to the level correspon-
ding to the number of cups required with cold water.
2. Bend the lower fold of the paper fi lter (size 1x4), place it into the fi lter funnel
and fi ll it with coffee powder (approx. 1 teaspoon for 2 cups).
3. Close the water tank lid.
4. Place the pot evenly on the base. Please ensure that the lid is on the pot.
5. Switch on the appliance (the LED in the switch lights up).
6. The brewing lasts about 10 to 15 minutes.
7. Your appliance is provided with a drip stop. By removing the pot, before the
water runs through the fi lter completely, it avoids that the coffee drips on the
base. If there is still water in the tank or fi lter, make sure that the pot is placed
back under the fi lter to avoid overfl owing.
8. When the coffee stops fl owing into the fi lter, you can remove the pot.
9. Switch off the appliance (the LED in the switch is off).
To select the aroma, change the setting between „strong coffee" (
„weak coffee" (
• De-scaling is necessary when the brewing time increases substantially.
• Use only commercially available citrus acid-based de-scaler. Follow the recom-
mended instructions for use.
1. Always pull he plug before cleaning and wait for the appliance to cool down.
2. Clean the outside of the appliance, if necessary, with a slightly moist cloth
without any detergent.
3. The fi lter holder can be washed as usual in warm washing up water.
4. Do not immerse the pot in water. Wipe the outside with a moist cloth. You can
clean the inside with warm water. If necessary, use a soft brush.
05-KA 157 CB Van 31
Electrical connection
Operating
Aroma selection switch
) according to taste.
De-scaling
Cleaning
GB
) and
31
18.07.2005, 8:35:58 Uhr