Makita DHR242 Manuel D'instruction page 9

Installing or removing the bit
Clean the bit shank and apply bit grease before install-
ing the bit.
1
► 1. Bit shank 2. Bit grease
Insert the bit into the tool. Turn the bit and push it in until
it engages.
2
1
► 1. Bit 2. Chuck cover
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
2
1
► 1. Bit 2. Chuck cover
2
Bit angle (when chipping, scaling or
demolishing)
► 1. Action mode changing knob 2. O symbol
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the
bit to the desired angle.
Depress the lock button and rotate the action mode
changing knob to the
the bit is securely held in place by turning it slightly.
Depth gauge
1
2
► 1. Hole 2. Depth gauge 3. Loosen 4. Tighten
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole in the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip.
9 ENGLISH
2
1
symbol. Then make sure that
4
3