Publicité
Les langues disponibles
Les langues disponibles
Standard djustable Undershelf (for DHT Series only)
assembled BEFORE securing legs to table.
*
Figure 1
1. Place table on top with gussets facing up.
Caution: Use cardboard or other material to prevent scratching top.
2. Install legs into gussets. Make sure rivet in leg is closer to gusset than
to the foot end.
3. lign undershelf gussets with legs, and slide undershelf down legs to
desired position. Do not force or beat corners as damage could occur.
4. Tighten set screws* in undershelf gussets to secure undershelf
(see Figure 1) and install feet into legs, using a rubber mallet.
5. Tighten set screws* in gussets to secure legs to table.
6. Place table on back with control knobs up.
7. See applicable cutting board mounting instructions below.
* To be compliant with NSF guidelines, either the supplied NSF set screw
caps (see illustration below) must be installed over all exposed set screws,
or exposed set screws must be filled with silicone sealant.
set screw
acorn nut
support shelf
bracket
washer
hex bolt
plate shelf
bracket
cutting board
channel (inside
assembly
cutting board
assembly)
drop bracket
machine screws
to screw into
unit
ASSEMBLY INSTRUCTIONS
NOTE: Legs and undershelf must be
NSF set screw cap
Note: OB/CB cabinet series do not require undershelf and leg assembly.
Optional Bolted Undershelf (for DHT Series only)
Figure 1
1. Place hot table on top with gussets facing up.
Caution: Use cardboard or other material to prevent scratching top.
2. Install legs into gussets.
3. Mount undershelf to legs by inserting bolt thru hole in leg and thru hole
in corner of undershelf and tighten with hex nut (see Figure 1).
4. Tighten set screws in gussets to secure legs.
5. Place hot food table on back with control knobs up.
6. See applicable cutting board mounting instructions below.
Standard Cutting Board (for all models)
1. ttach shelf support brackets to support shelf, using acorn nuts, washers, bolts
and predrilled holes. Note: acorn nuts must be at the top.
2. Install machine screws into threaded fasteners on hot food table. Do not tighten.
3. lign keyholes in mounting brackets with screws and mount support shelf/bracket
assembly to table. Tighten screws.
4. lign holes in cutting board with acorn nuts, and place cutting board onto
support shelf.
Optional Plate Shelf
1. Hook metal plate shelf into bottom flange of plate shelf brackets.
2. Using keyholes on support shelf brackets, mount plate shelf/bracket assembly
onto support shelf/bracket assembly.
Optional Hardwood Cutting Board
with Drop Brackets (for all models)
1. Mount drop brackets to table, using machine
2. Mount cutting board assembly to drop brackets
3. Raise cutting board up until it is in horizontal
drop
bracket
2
NOTE: Legs and undershelf must be
assembled BEFORE securing legs to table.
screws and threaded fasteners on table.
on table.
position and slide toward hot table.
Publicité
