Bartscher MX 250 Mode D'emploi page 29

WARNING! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should be
compared with that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
•
The power supply circuit with the socket must be protected by the fuse at least
16A. Only connect the device directly to the wall socket, do not use any extension
cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
Start-up
The device must be started according to the instructions below and in the specified
order.
1. Positive result of inspection in range of preparation;
2. Positive result of inspection in range of electric supply;
3. Connection of plug to appropriate socket;
4. Positive result of inspection in range of assembly;
5. Positive result of inspection in range of control before
start-up;
6. Positive result of inspection in range of condition of all
protective devices.
7. Place the food products manually in the pot.
8. Holding the device with both hands in
appropriate places:
a. put the mixing stick in the pot.
b.
start the device with use of ON/OFF switch, which
must be pressed until all food articles are processed.
9. When the processed food articles obtain desired properties, turn the device off and
put on appropriate work surface.
10. Remove the processed product from the pot: pour it into appropriate dish, holding
the pot with both hands.
WARNING!
Never immerse the device in the pot with processed food products deeper than the
immersion mark. Never start the device on the idle run.
- 28 -