Installation; Using Imageviewer When Dkc01Hsm_01 Is Connected - LEXIBOOK DKC01HSM_01 Manuel D'utilisation

1. Plug the USB cable into the computer and the digital photo frame.
The computer will detect the new hardware automatically and the
ImageViewer window should pop up on its own. The screen on the unit
will show "PC connecting."
. If this does not happen, unplug the USB cord from the computer and
plug it in again. This will not affect the functioning of the unit even if the
screen on the unit does not show "PC connecting."
. If you would like to go back into the program to edit your photos, please
launch the imageview.exe file from your computer.
USING IMAGEVIEWER WHEN DKC01HSM_01
IS CONNECTED TO YOUR PC
1. ImageViewer will automatically display all the pictures which are already
loaded into the frame.
. You may select a photo in the digital photo frame by clicking the desired
photo in the left box.
. Once you click on a photo, you can move it up or down the list. This
changes the order in which the photos are displayed when using the
digital photo frame slideshow function.
4. You may also delete a photo by selecting it and clicking "Delete." This will
permanently delete the photo from the list.
5. Click "Clear" to clear the entire contents of the digital photo frame.
6. The "Edit" button can be used to crop a photo.
a. In editing mode, place the cursor at the bottom right corner of the
picture, then click and hold. Move the cursor inside the picture to
resize the selection. Click and hold inside the selection area to move
the selection.
b. Click "Auto Stretch" to fill up the entire screen with the photo and
click "Smooth Edit" so that the photo appears clear in the photo
frame.
7. To add an image to the digital photo frame, click "Add Image as ..." Then
select the directory where the image was saved and click "Open."
a. Once this is done, the image will appear in the left box.
b. At this point, the image can be manipulated like any others.
Copyright © Lexibook 008

INSTALLATION

11