Assembly - Greencut HEC112 Manuel D'utilisation

ASSEMBLY

HANDLE
CASTER
Slightly spread apart split bearing on shaft it if fit loose. Crimp split bearing slightly with pliers. Make only slight
adjustments until caster fits properly.
DRAWER SLIDES
If it becomes necessary to remove drawers, follow these drawer removal instructions:
1. Pull drawer all the way out, then push back a fraction of an inch.
2. Insert a screwdriver into slot in the slide and push in on the stop until it clears the lance. Repeat the
precedure on the other slide amd remove drawer.
3. To re-install drawer, pry stop far enough out to engage lances (3/16" to 1/4") and push drawer onto slide
until stops engage lances.
ATTENTION:
•
•
•
Lubricate the top and the bottom channels of the drawer slides at least twice a year.
Do not open more than one loaded drawer at a time.
The maximum loading capacity is 70 Kg.
3
21
2
5
4
EN