Weelko WKE008 Mode D'emploi page 7

6. After use, do not pour the wax when
it is still liquid. Firstly, turn off the equi-
pment and wait for the wax to become
cold. Then, turn on the equipment again.
When the wax at the bottom starts mel-
ting slightly, it will be easier to remove
the wax block.
7. Pay attention not to spatter the wax
on the machine, especially on the tem-
perature controller. If this accidentally
happens, clean it immediately before the
wax becomes hard.
8. If the power cord is damaged, buy the
component at the manufacturer or at an
authorised technical service.
9. Avoid sun exposure the 24 hours fo-
llowing hair removal.
10. Use the device responsibly and take
safety precautions.
11. Keep the device away from children.
TECHNICAL SPECIFICATIONS
CAPACITY
INNER POT DIAMETER
TEMPERATURE
RATED POWER
RATED VOLTAGE
500 ML
110 MM
95ºC
100 w
AC 220V ~ 240V
EN
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556