Cleaning And Maintenance - Beurer Barbers Corner HR 6000 Mode D'emploi

attachment, we recommend you initially start with the longest cutting length
so that you can slowly work your way to your desired length. Turn the selection
dial on the length-adjustable comb attachment to select the required trim-
ming length. The settings on the dial correspond to hair length in millimetres.
• Press the ON/OFF switch
begins to light up.
• Guide the device slowly through the body hair. Ensure that the stainless steel
razor blade sits as flat against the body as possible.
• Always only trim small areas.
• Cut the hair against the direction of growth. If the hair grows in different di-
rections, use the device in multiple directions.
• Press the ON/OFF switch
operating display turns off.

9. Cleaning and maintenance

Cleaning the device
WARNING
• Always pull the mains adapter out of the socket before cleaning the device.
Risk of electric shock!
• Remove the length-adjustable comb attachment before cleaning.
• Only clean the housing of the device with a soft cloth dampened with warm
water.
• Do not clean the device with highly flammable liquids. Risk of fire!
• Do not clean the device in the dishwasher.
• Clean the stainless steel razor blade and the length-adjustable comb attach-
ment after each use to prevent lots of hair getting jammed inside, which could
otherwise impede flawless operation.
• Leave the length-adjustable comb attachment to dry completely before you re-
attach it to the device.
• If you do not use the device for a long period of time, place the protective cap
over the stainless steel razor blade and store the device and the length-ad-
justable comb attachment in the storage bag supplied.
Cleaning the stainless steel razor blade
After use, blow on the length-adjustable comb attachment and the stainless
steel razor blade to remove any hair from them. You can also carefully remove
wet hair with your fingers.
WARNING
When cleaning using your fingers, ensure that you do not injure yourself on the
sharp edges of the stainless steel razor blade.
To clean the stainless steel razor blade particularly thoroughly, you can also
rinse it under running water. To do so, proceed as follows:
1. Carefully grasp the stainless steel razor blade from below
using your thumb and index finger. Pull the stainless steel
razor blade up and off.
When removing the stainless steel razor blade, ensure
you do not injure yourself on the sharp edges.
to switch on the device. The operating display
again to switch off the device after use. The
23