Operations - Bissell Total Floors 73D2 Série Guide De L'utilisateur

O
perations
Power button
Turn the power ON or OFF by pressing lightly
downward on the power button (
Power cord
The power cord is located at the rear of the vacuum.
Gently pull out the power cord, watching for the
yellow line. Stop pulling the power cord once the
yellow line is visible. There is also a red line, which
indicates the end of the usable cord. Do not pull the
power cord out beyond the red line.
Automatic cord rewind
Your vacuum is equipped with an automatic cord
rewind. When cleaning is finished, press the power
button OFF ( ) and grasp the plug to disconnect
from the electrical outlet. Hold the plug and press
the automatic cord rewind button to rewind the cord
automatically.
Motorized powerhead
Turn the power brush ON by pressing the power
button ( ) on the handle. Turn the power brush OFF
by pressing the power button (
NOTE: The power brush will
automatically turn off if the rotator bar
is blocked by clogs (hair, cloth, etc.) for
your protection. In that case, turn off
the power head, unplug the vacuum,
clean the clog, and re-start the power
brush.
To remove the powerhead from the wand, firmly press
in on the powerhead release button with your thumb.
6
w w w . b i s s e l l . c a
w w w . b i s s e l l . c a
).
) again.
Power Button
CAUTION:
Be careful to avoid injury as
cord retracts very quickly.
Powerhead Release
Button
8 0 0 . 2 6 3 . 2 5 3 5
1 - 8 0 0 . 2 6 3 . 2 5 3 5
Automatic Cord
Rewind Button
7