Publicité
eNet module émetteur radiofréquence
Device configuration
Parameter name
Function
Operating mode
Advanced settings
Parameter name
Manual commissioning
Extended channel settings
Parameter name
Manual commissioning
Local Operation
6.3 Aide en cas de problème
La LED d'envoi clignote après un appui bref sur une touche.
Cause : la batterie dans l'émetteur mural est presque vide.
Remplacer la batterie (voir chapitre Insérer la batterie).
Le récepteur ne réagit pas, la LED d'envoi indique une erreur de transmission. La LED
d'envoi clignote rapidement pendant env. 3 secondes.
Cause 1 : portée radio dépassée. Les obstacles de construction réduisent la portée.
Utilisation d'un répéteur de transmission radio.
32595513
J0082595513
Setting options, Basic set
ting
Rocker, Other modes, Unused
Basic setting: Rocker
App use, lock-out protection,
forced operation, wind alarm,
sun protection, twilight
Basic setting: App use
Setting options, Basic set
ting
On, Off
Basic setting: On
Setting options, Basic set
ting
On, Off
Basic setting: On
On, Off
Basic setting: On
9/10
Explanations
Rocker
The channel works as a chan-
nel button. Setting is always
made in pairs.
Other modes
The channel works as a scene
button. Setting is always made
in pairs.
Unused
The channel is not displayed
in the eNet SMART HOME
app and is disabled for use in
the commissioning interface.
Setting the type of scene used
for a scene button. Setting is
always made in pairs.
Explanations
Disables manual commissio-
ning for all device channels.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Explanations
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Blocks the device channel for
local operation.
22.03.2017
Publicité
