Gladiator GAWB04HWEG Instructions D'assemblage page 6

3. Attach leg assemblies
Attach the leg assemblies (P1) to the workbench top (P4)
using eight of the provided 3/8" (9.5 mm) x 1
screws (F16). Make sure the screws are inserted straight into
the holes. Loosely install the screws using a 9/16" socket
wrench. Do not tighten the screws completely.
NOTES:
Tightening the screws at an angle can place excessive
■
stress on the screws, which may cause the screws to fail.
The holes in the legs are oval to allow space for minor
■
adjustments as the workbench is assembled.
5. Attach back panel to workbench top
Attach the back panel (P3) to the workbench top (P4) using
the remaining screws*. Make sure that the screws are inserted
straight into the holes. Tighten the screws using a 9/16"
socket wrench.
NOTE: Tightening the screws (F16) at an angle can place
excessive stress on the screws, which may cause the screws
to fail.
*NOTE: For 4' workbench, use two screws (F16).
For 6' workbench, use three screws (F16).
For 8' workbench, use six screws (F16).
6
08-Feb-2018 10:19:55 EST | RELEASED
4. Attach back panel to leg assemblies
Using a 5 mm wrench, attach the back panel (P3) to the leg
/ " (3.81 cm) assemblies (P1) with the four provided M8 hex-head bolts
1
2
(F14). Do not tighten the bolts completely.
6. Tighten leg assembly bolts
Using a 5 mm wrench, tighten the bolts to attach the back
panel (P3) to the outer leg assemblies (P1) completely.
NOTE: Do not overtighten the bolts and screws.
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")