Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1) Remove the external cover and the internal cage (HP602LG model).
2) Fix the bottom of the siren to the wall using the rawplugs and holes provided (see figure 1).
3) Remove the adhesive tape (A) holding the anti-opening/anti-removal limit switch and lift it . The screw on which the
limit switch rests is calibrated by the manufacturer to close the contact when the cover is fitted. Either tighten or loosen
the screw as required if the switch is not closed because the supporting wall is rough. Close the limit switch (B).
4) Fit the battery in the housing and connect the fast-on: red wire to positive, black wire to negative. The siren will not
sound and the flasher will blink at the first power-on. The unit will be set for operation after applying the block signal
(BL) and the TC signal.
5) Close the siren mounting the internal cage (HP602LG model) and the external cover.
2 INSTALLATION
HP602L-HP602LG
11
Publicité
Table des Matières
