Working Methods; General Working Instructions; Freeing Up A Jam; Sharpening, Turning Or - Grizzly EMH 2440 Traduction De La Notice D'utilisation Originale

Working methods

General working instructions

Keep enough distance to the
shredder since long branches can
be spun off while being drawn into
the shredder.
Wear ear and eye protection
Wear hand protection
• When feeding branches to the unit,
keep holding them until they are auto-
matically drawn in.
• Adapt to the speed of the shredder
and avoid overloading the unit.
• To avoid the unit clogging up, mix the
branches with twigs and gardening
waste allowed to wither for several
days.
• To prevent the blades from becoming
blunt quickly, remove mud and stones
from the roots before shredding.
• Do not shred but directly compost all
soft and wet material such as kitchen
waste.
• Keep a couple of dry branches to use
them for cleaning the unit at the end.
• Do not turn off the unit until all the ma-
terial has passed the blades. Remain-
ing material may otherwise block the
blade when you restart the unit.
D

Freeing up a jam

Before starting to service or clean
the unit, turn off the unit, pull the
power plug, and wait until the blade
stands still. There is a risk of injury
and a risk to life from electric shock,
fire and rotating blades.
• Check that the power plug (
pulled properly.
• Unlock the housing interlock (8).
• Tip forward the front part of the shred-
der housing. You can remove it com-
pletely and put it aside.
• You now have full access to the
blades (18).
• Remove the blockage.

Sharpening, turning or

D

replacing the blades

Before starting to service or clean
the unit, turn off the unit, pull the
power plug, and wait until the blade
stands still. There is a risk of injury
and a risk to life from electric shock,
fire and rotating blades.
• Check that the power plug (
pulled properly.
• Unlock the housing interlock (8).
• Tip forward the front part of the shred-
der housing. You can remove it com-
pletely and put it aside.
• You now have full access to the blade
(18).
• Use a screwdriver to block the blade
plate (16). Slot the screwdriver into
the access hole (19) and carefully turn
the blade plate (16) until one of the
two blocking apertures appears. Now
block the blade plate (16) by slotting
the screwdriver right through it.
• Use the Allen wrench (15) to unscrew
the screw (17) in the blade plate (16)
and remove the blade (18).
To assemble the blade you must
use a new screw and tighten it with
an torque of 16 Nm.
GB
7) is
A
7) is
A
77