Disposal; Technical Data - Inanny NC112 Manuel D'utilisation

Problem
What should I do if I have forgotten my
password?
I have not received an e-mail, even
though I have used the "Forgot
password" function.
If I try to add a new camera to my user
account, no available cameras
appear .
During the set-up process, no camera
appears in the last step. The set-up
process is interrupted.
If I try to view the transmission image,
I received the message that I should
update my Firmware.

11. Disposal

For environmental reasons, do not dispose of the device in the household
waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of
the device in accordance with EC Directive - WEEE (Waste Electrical and
Electronic Equipment). If you have any questions, please contact the local
authorities responsible for waste disposal.

12. Technical Data

•
Frequency 2.4 - 2.483 GHz
•
Digital receiver
•
Infrared technology
•
Camera dimensions: 9.0 x 6.5 x 5.8 cm
•
Camera weight: 95g
•
Application temperature: 0 - 50°C
•
Power adaptor: By Ten Pao International Ltd.
Input:
Output:
Use only the power supply listed in the user instructions.
We hereby guarantee that this product complies with the European R&TTE Directive 1999/5/
EC. Please contact the specified service address to obtain further information, such as the
CE Declaration of Conformity.
S005ANB0500100 (For UK)
S005ANV0500100 (For EU)
100 - 240 VAC, 50/60 Hz, 300mA
5VDC, 1000mA
Solution
In the app tap "Forgot password" and enter your e-mail
address. A new password will be sent to your e-mail
address.
1. The e-mail may be in the spam folder of your e-mail
account. Check the spam folder for the e-mail.
2. The e-mail may not have arrived yet. Check your
e-mail account again after a few minutes.
Press the "PAIR" button on the camera for 5 seconds
and try again.
Switch the camera of and back on again. Press the
"
PAIR" button until there is a beep. Wait for a minute until
the indicator lamp flashes. The camera is now r
the set-up process. Start the set-up process for the
camera again.
Conduct a Firmware update. We update the app from
time to time to constantly improve the camera function.
10
eady
for