Water Inlet Hoses; Vacation, Storage, And Moving Care - Inglis IFR42001 Guide D'utilisation Et D'entretien

Cleaning the dispenser drawer
The dispenser drawer is removable for easy cleaning.
1. Open the dispenser drawer. Unlock the dispenser drawer by
pressing on the plastic part of the softener compartment
marked "PUSH." (Letter A in dispenser illustration.)
A. Dispenser drawer release
2. Remove the drawer.
3. To avoid damage to the finish, do not clean the drawer with
cleaning solvents or abrasive cleansers.
4. Replace the dispenser drawer in the washer.
Cleaning the lint filter
The lint filter should be cleaned about once a month. Make sure
the washer is not running before opening the filter door.
1. Place a pan or towel under the filter door, since a small
amount of water could spill. Open the filter door.
2. Remove the filter by rotating it a half-turn counterclockwise and
pulling outward.
3. Clean the filter with a soft brush under running water until all
residue is removed.
4. Replace the filter and turn it clockwise until it is securely locked
A
5. Close the filter door.
To clean the control panel, use only a warm, damp cloth.
Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
Operate your washer only when you are at home. If you will be on
vacation or not using your washer for an extended period of time,
you should:
1. Unplug washer or disconnect power.
2. Shut off both water faucets.
3. Disconnect water inlet hoses from faucets.
4. Place a pan or towel under the filter door, as a small amount of
5. Reinstall the lint filter and close the filter door.
in place. Give the cap a gentle tug to confirm that the filter is
secure.
Cleaning the control panel
Do not spray water or cleaning solvents on the control panel.
Do not use abrasive cleaners or scouring pads on the outer
surfaces because they will scratch the finish and could
remove the writing on the control panel.
Some paper towels may also scratch the finish.

Water Inlet Hoses

Vacation, Storage, and Moving Care

Non-use or vacation care:
Unplug washer or disconnect power.
Turn off the water supply to the washer. This helps avoid
accidental flooding (due to a water pressure surge) while you
are away.
Slightly open door to provide ventilation.
To winterize washer:
water could spill. Open the filter door and remove the lint filter
to drain. See "Cleaning the lint filter" in the "Cleaning Your
Washer" section.
15