Elcoman KOBRA 245TS Mode D'emploi page 12

PAPER JAMS
Should the shredder jam, do the following:
- Unplug the machine from the mains.
- Open the cover with the key (only for high security "HS"
models).
- Remove the top cover (23) of the automatic feeder by
pressing the buttons on the sides as indicated in figure 6
and pull upwards.
- Remove the two knobs (13) as indicated in fig. 7 and
remove the metal plate (14)
- Remove the jammed paper.A manual rotation of the rubber
rollers helps in clearing the jam.
Once the blades are free of the paper jam replace the metal
plate (14) secure it with the two knobs (13), then put back on
the top cover (23).
Now your shredder is ready for operation
LOCKABLE COVER
All KOBRA shredders equipped with an Automatic Feeder
can be supplied with a special Lockable Cover (21) including
a High Security non-duplicable key to protect documents
from unauthorized persons while the Automatic Feeder is
processing the shredding operation.
INSTALLATION;
Position the cover over the holes on the hinges and insert
the rivets which come with the cover as indicated in fig.8.
WARNING: once the cover has been fitted with these special
rivets it can no longer be remove
SHRED gUARD
The shredders in the Kobra 245TS , 260TS, Kobra 270TS and
Kobra 310TS range can also come fitted on request with the
'SHRED GUARD' (METAL DETECTION SYSTEM).
This system is set to detect the presence of metal objects
accidentally inserted into the machine (2) of a size which can
damage the cutting knives and instantly cuts it off before
they reach the cutting blades thus prolonging the life of the
cutting blades.
INSTALLATION fIg.2
The SHRED GUARD requires no special installation since it is
fitted inside the shredder in the factory.
OPERATION
Once the machine has been plugged into the mains power
supply, press the ON/OFF button (O) and the bar (P) lights
up and begins flashing for about 30 seconds in order to give
the METAL DETECTION SYSTEM time to start up.
As soon as the bar (P) goes off, your shredder is ready for
use.
When paper is inserted into the throat (2), the bar (P) lights
up and the machine automatically begins shredding.
If by any chance the material inserted into the throat (2)
of the shredder contains metal objects of a size which
can damage the cutting knives, the machine shuts down
automatically before these objects reach the cutting blades.
The presence of metal objects is signalled by the flashing
light bar (P).
Press the REVERSE button (11) and the machine goes into
reverse so that the operator can remove the metal objects
present on the sheets of paper.
The machine is now ready for shredding.
WARNING!!! When the machine is first switched on, it takes
about 30 seconds for the SHRED GUARD to start up.
In the meantime, the light bar (P) flashes and no shredding
can be carried out.is ready with oiled cutting blades.
12