Operation - Yard force NX 60i Guide D'installation D'origine

GB

Operation

Control panel
Initial interface
when power on your robotic mower, after entering the defult PIN 0000, you will see the initial
interface on the display.
Enter PIN Code
* * *
Current signal status Robotic mower working time
S1 02:50-13:50 03:50-15:00 68%
*Robotic mower
Mon Tue
working date
*NOTE: Inverted color means date was selected.
Mon
Mon
*
4x
1 2
Battery pack
remaining capicity
Wed Thu Fri Sat Sun
St andby
Current mower status
10
Before starting your robotic mower
Please follow below steps to adjust the time setting before starting your robotic mower.
1. Press the button to enter the menu setting.
Timer Sensor PIN English
1 2 3 4
2. Press the button to enter time setting
System date
System time
1 2
3
3. Press the button to set the system date
Set system date
2021-01-29
4. Press the button to set the system time
Set system time
13:57
5. Press the button to enter next page
Working date Working time
1 2 3
6. Press the button to set the working date
- Press the relative numbers to select the working date your required.
Set working day
Mon Tue Wed Thu Fri Sat Sun
1 2 3 4 5 6 7
7. Press the button to set the working time
- Press the relative numbers to select the working time your required.
Set working time
Sun
Mon Tue Wed Thu Fri Sat
1 2 3 4 5 6 7
02:50-13:50 03:50-15:00
NOTE: If the working day is activated, then the blinking cursor will move to specified time
setting.
11
GB