Startup - Beem Leopard G5 Mode D'emploi

EN
Electrical connection
For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 10 A automatic circuit
breaker.
■ Ensure that the mains lead is undam-
aged and is not laid over sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the cable to prevent risk of trip-
ping.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
BEEM - Elements of Lifestyle

Startup

Unpacking
Remove the appliance, all accessory
‹
parts, also out of the pusher, and the
user manual from the box
Remove all packaging materials and
‹
protective foils from the product and
the accessories before using it for the
first time.
NOTE!
► Do not remove the rating plate or
any warning signs on the appliance.
► If possible, keep the original packag-
ing during the guarantee period in
order to be able to pack the ap-
pliance properly in the event of a
guarantee claim. Transport damage
will invalidate the guarantee.
Check the delivery contents
Check for visible signs of damage or
‹
missing items.
Report incomplete or damaged con-
‹
tents to your supplier immediately.
Before using for the first time
Clean the appliance and the acces-
‹
sories, as described in the section
Cleaning and care (page 25).
Leopard G5
19