Televes COFDM-PAL Manuel D'utilisation page 46

User manual
the lowest channel in the selected table is
automatically chosen. When going from chan-
nel mode to frequency mode, the frequency of
the channel that was selected is displayed.
Note: In the input, you can only select the
channels that have got a frequency
range within the permitted input mar-
gin (174-230 / 474-858 MHz).
l.- MPEG decoder version
Indicates the software version of the MPEG
decoder. For example; Version 1.40:
5.3.- Parameter recording
To record data, you must press the
button for approximately 3 seconds. If the
data has been recorded correctly, this is
indicated by the following:
If the configuration data is modified, but not
recorded, the previous configuration is
retrieved after approximately 30 seconds, in
other words, the changes made are
cancelled.
Whenever the frequency or input channel is
modified and once the unit has received the
COFDM signal, an automatic search will
begin of all the available services. The time
this takes will depend on the number of
multiplex services. While this is being
carried out, the display will show the follo-
wing message:
During this analysis of the input signal, it is
not possible to carry out any operation with
the programmer.
You can also carry out a scan if you detect a
change in the conditions of the input signal.
46
COFDM-PAL
5.4.- Status LEDS
Finally, the programmer's LEDS indicate the
following operational status:
A B C
Correct operation
A B C
Low input signal level
A B C
Unlocking of the COFDM demodulator
A B C
The Audio and/or Video has not been tuned
If the LEDs are switched on, this means that
it is working properly. If one of them is
switched off, this means that something is
not working properly.
NOTE: The "C" led will switch off whene-
ver the selected program has not been
tuned in properly. This will happen every
time a scrambled service is selected.