Olimpia splendid PELER 5 Mode D'emploi Et D'entretien page 14

Please pay attention when adding water to:
Unplug the appliance
Before refilling, remove any remaining water
Use only clean water
Fill the water tank slowly
Pay attention to the front water level display window to not exceed the maximum level.
Lock the tank with the slider pin, to prevent the tank falling
Before connecting the power supply, please read the safety precautions and make sure that
the power socket voltage conforms to the requirements of the air-cooler unit.
After turning on the power, the air-cooler will sound Bi Bi twice, then enter Standby mode. At
this time other keys are invalid except the Power on/speed key (Power on sound: BiBi, Key
Sound: Bi, Switch off sound: Bi)
1. On-off Key: On pressing this key, issuing a Bi sound, circuits enter normal working state,
power indicator switches on; Medium fan speed shifts to low fan speed after 3 seconds; in
working state, pressing this button will make a Bi sound, then it will go to standby status.
2. Speed Key: Turn the knob clockwise to increase the speed (low, medium,
high) and anticlockwise to reduce the speed. Each time the key is pressed
on the remote control, the speed switches low-medium-high-low-medium.
3. Swing Key: press this key to switch oscillation on, the indicator switches on; press the key
again, the indicator switches off, and so on.
4. Cooling Key: to switch the cooling function on, relevant indicator switches on, other water
tank indicator switches on as well; press the button again, the cooling function and relative
indicator will turn off, and so on.
4.1. When the Cooling function turns on, the water pump will work for 45 seconds before te-
sting the water level; if the water level remains below the set level for 5 seconds, the cooling
function will turn off automatically, and the BiBi sound will last for 5 seconds.
5. Timer Key: In the initial state, press this key to open the timer function, setting mo-
del:1-2-3-4-5-6-7-8-9-0-1.....and so on, LED indicates a corresponding time.
6. MODE button: Press the MODE button, the NATURE indicator will turn on. Press MODE
button 2 times to turn to the SLEEP mode; press Power button 3 times to turn to the "nor-
mal" mode again.
In NATURE mode, the appliance simulates natural changes in wind strength, with LOW,
MEDIUM or HIGH intensity.
In SLEEP mode, the appliance simulates natural changes in wind strength as in nature
mode, but every 30 minutes the appliance switches to a lower intensity level until it reaches
LOW intensity. Once it reaches LOW intensity level, the appliance stays at this level until
it is switched off by the user.
NOTE
- At first use, the appliance may have a slight odor
- At each re-starting, the appliance may have water condensate on the grid
14
OPERATING INSTRUCTIONS