Operating The Transmitter; Operating The Receiver - Ebode ALDS58 Guide Utilisateur

8. Operating the transmitter

After powering up the transmitter, the transmit light will go on for approximately five
seconds while the transmitter initializes.
After initialization, the transmit light will go out.
Initially, set the transmitter volume control to a middle setting.
Once audio is detected at the audio input, the transmit light will go on and the transmitter
will transmit the audio signal.
When audio is no longer detected, the transmitter will go into standby mode after
approximately one minute. The transmit light will go out. During standby mode, no signal
is transmitted.

9. Operating the receiver

As soon as a valid transmitter signal is received by the receiver, the receiver will output
the received audio signal to the speaker outputs. You can change the audio level by
adjusting the receiver volume control.
In order to achieve maximum transmission quality, the transmitter volume control should
be set to match the audio level of your audio source as follows:
1) Set the receiver volume control to a low level to prevent clipping inside the receiver.
2) Set your audio source to output the maximum audio level that you will encounter during
normal operation.
3) Turn the transmitter level control knob to the position that yields maximum audio
loudness to the speakers without any clipping (distortion). If the transmitter level is set too
low, the dynamics of the transmission are not fully used. If the level is set too high, audio
clipping (distortion) will occur inside the transmitter.
4) Turn the receiver volume control to a setting that yields the desired volume from the
speakers.
If no audio signal is received for more than 20 minutes, the receiver will go into standby
mode (power-down mode).
25-3-2013 6 ebode ALDS58