AEG HC 5593 Mode D'emploi page 24

English
24
Commissioning
1. Fully unwind the mains cable.
2. Insert the plug in a duly installed 230 V~, 50 Hz socket.
3. Press the on/off button (3) to turn the appliance on.
NOTE:
• The device always starts with the temperature set to
180 °C. This is shown in the display.
4. Select a temperature between 120 °C and 220 °C:
• With the "-" button you can reduce the temperature
by 10 °C each time.
• With the "+" button you can increase the tempera-
ture by 10 °C each time.
NOTE:
• The display shows the actual temperature value.
• When the set temperature is reached, the display
shows "READY".
General Use
• Select the desired temperature as described above.
• The device must be used only for dry hair.
• Take a strand of hair and pull it carefully downwards until
it is taut.
• The remaining hair should be put up or fixed in place.
• Before the halves are pressed together for approx.
5 seconds, we recommend that you ensure that the hair is
positioned correctly. Always begin at the base of the hair
and move the device in the direction of the hair tip.
• In order to produce a uniform appearance it is important
that the next strands fall in one line.
Ionizing function with tourmaline coating –
Reduction of electrically-charged hair
The anti-static effect allows easier hair styling. The hair does
not dry out, it becomes smooth and sparkling.
Switch-off
• Press the on/off button (3) to turn the appliance off.
• Remove the mains plug.
• Leave the device to cool before putting it away! To this
purpose place the device on one side of the housing or
hang it up by the suspension lug.
• For space-saving storage, you can push the rods of the
appliance together and lock them. For this, press the lock
(5) down.
Safety Switch-Off
This device features a safety switch-off. In case you forget to
switch the unit off after use, it automatically turns off approx.
60 minutes after the last time a button was pressed.
Cleaning and care
WARNING:
• Before cleaning remove the mains lead from the
socket.
• Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise this
might result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a soft, dry cloth – without any ad-
ditional cleaning agents.
• The heating surfaces can be cleaned with a slightly damp
cloth. If necessary you can use a commercial dish washing
detergent.
• Dry the heating surfaces off thoroughly each time they
are cleaned!
Technical Data
Model: .................................................................................. HC 5593
Power supply: .................................................110-240 V AC, 50 Hz
Power consumption:.................................................................65 W
Protection class: ................................................................................II
Net weight: .............................................................................0.52 kg
Subject to technical changes without prior notice!
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.