Publicité
Preparación (cont.)
Marque el lugar del orificio del pedestal en el piso.
Con cuidado retire el lavabo del pedestal y retire ambos el lavabo y el pedestal
del área de instalación.
2.
Install the Lavatory
Finished Wall
Mur fini
Pared acabada
Install hanger bolts.
Installer les boulons d'ancrage.
Instale los pernos de sujeción.
Backing
Renfort
Refuerzo
CAUTION: Risk of product damage. Do not overtighten connections.
Overtightening may break or chip the lavatory or pedestal.
Drill 1/4" mounting holes at the marked locations on the finished wall and the
floor.
NOTE: You may also use other fastening devices of sufficient size and strength.
Install the hanger bolts to the backing material so they extend 1" (2.5 cm) from the
finished wall.
Move the pedestal over the drilled hole in the floor, and carefully secure the
pedestal to the floor with a lag bolt and washer.
Carefully set the lavatory basin on the pedestal so the hanger bolts extend through
the mounting holes.
Verify the basin is positioned as desired.
Install the cap nuts and washers to the hanger bolts; carefully tighten until secure.
Do not overtighten.
If not already installed, install the faucet and drain to the lavatory according to
the manufacturer's instructions.
Kohler Co.
Basin/Bassin/Lavabo
Install cap nuts and washers
to the hanger bolts.
Installer les écrous borgnes
et les rondelles sur les
boulons d'ancrage.
Pedestal
Instale los tapones roscados
Colonne
y las arandelas en los pernos
Pedestal
de sujeción.
Secure pedestal with lag bolt and washer.
Sécuriser la colonne avec le tire-fond et
la rondelle.
Fije el pedestal con el perno de fijación y
la arandela.
7
1087261-2-B
Publicité
