Using The Stick Mixer; Using The Whisk; Cleaning & Maintenance - Inventum CMX435S Mode D'emploi

4

using the stick mixer

Warning: the blades of the blender shaft are extremely sharp.
• Take the motor part and the blender shaft. Attach the blender shaft to the motor part by
turning the blender shaft clockwise. To loosen it, turn the blender shaft the other way.
• Plug in the appliance.
• Lower the stick mixer into the food.
• Press the on/off button for setting 1 or 2.
• As soon as you release the button, the stick mixer will stop.
• When you have finished mixing or blending and released the button, wait until the knives have
stopped turning, before approaching the blender shaft with your hands.
Attention: do not activate the stick mixer constantly, this can cause engine problems. Do not
use the stick mixer for more then one minute continuously, wait until the engine is cooled down in
three minutes before operating it again. Blend larger quantities in multiple sessions.
The stick mixer can't exceed a running time of 15 seconds without a load.
Always unplug the appliance from the supply if it is left unattended and before assembling, disassembling and during cleaning.
You can use the stick mixer in the measuring cup and also in another bowl. When blending directly in a saucepan while cooking, take
the pan from the stove first to protect the appliance from overheating.
The anti-slip base is also an airtight lid for the measuring cup.
5

using the whisk

Use the whisk for example for making whipped cream or beating egg whites.
• Take the motor part, the connector and the whisk.
• Attach the connector to the whisk.
• Attach the whisk to the motor part by turning the connector clockwise.
• Plug in the appliance.
• Place the ingredients in the measuring cup. Make sure the measuring cup is not too full.
• Place the whisk in the measuring cup.
• Press the on/off button for setting 1.
• As soon as you release the button, the whisk will stop.
Always unplug the appliance from the supply if it is left unattended and before assembling,
disassembling and during cleaning.
To remove the whisk after use, turn it anti clockwise from the motor part and pull the whisk
from the connector.
6
cleaning & maintenance
Always unplug the appliance from the supply if it is left unattended and before assembling, disassembling and during cleaning.
Disassemble the motor part from the accessory.
• Wipe the motor part and the connector with a damp cloth.
• Rinse the measuring cup, the lid and the blender shaft with water or clean them in the dishwasher.
• Do not use any abrasive or strong detergents. These can damage the housing.
• Never place the motor part, the power cable or the plug in water or any other liquid.
• These accessories are dishwasher proof:
- blender shaft
- measuring cup with anti-slip base/lid
- whisk without the connector
Be careful when cleaning the accessories by hand. The knives of the blender shaft are extremely sharp.
CMX435S-instructions.indd 11
English • 11
6-6-2018 12:38:45