Greencut GTC190X Manuel D'utilisation page 60

60
USE
COLD START
1. Move the throttle lever up to the "START RUN" position.
2. Press the choke 3 times.
3. Pull the starter handle slowly once and allow it to retract normally. Then pull quickly.
4. Release the starter handle gently.
5. When the engine starts and warms up, move the lever to the working position (halfway) and the throttle
speed will increase.
1
START WITH WARM ENGINE
Follow the same steps as cold start but start the machine with the accelerator lever in the working position (half-way).
CLUTCH
The clutch switches the engine power to the transmission on and off. The clutch lever has a safety lock that must be
released before the clutch lever can be pressed.
Press the clutch lever, and the rotating blades will rotate, release the clutch and stop.
STOP
In case of emergency:
1. Move the throttle lever to the "STOP" position.
In normal use:
1. Disengage the clutch.
2. Move the throttle lever to the "STOP" position.
2 3