General Power Tool Safety Instructions - Kamikaze Volpi KV 362 Guide De L'utilisateur

ELECTRIC PRUNING SHEARS
2.3. SYMBOLS ON CHARGER
Warnings
Only use the charger indoor
Insulation Class II
Electrical equipment cannot be disposed to domestic waste

3. GENERAL POWER TOOL SAFETY INSTRUCTIONS

Warning! Read all safety directions and instructions.
Omissions in the compliance with safety directions and instructions
can cause electric shock and fire and/or severe injuries.
Retain all safety directions and instructions for future use.
The term "Power Tools" used in the safety instructions refers to mains-
operated power tools (with power cord) and battery-operated power tools
(without power cord).
3.1. SAFETY OF WORKING AREA
• Keep work area clean and light. Cluttered or dark areas will cause
accidents.
• Do not operate power tools in explosive and flammable atmospheres,
such as in the presence of flammable liquids, gases or dust. Power tools
create sparks, which may ignite the dust or fumes.
• Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control of power tool.
www.kamikazevolpi.com
34
ELECTRIC PRUNING SHEARS
3.2. ELECTRICAL SAFETY
• Power tool plug must match the outlet. Never modify the plug in anyway.
Do not use any adapter plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce risk of electrical shock.
• Avoid body contact with earthed or grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
• Do not expose power tools to rain or wet conditions. Water entering a
power tool will increase the risk of electric shock.
• Do not abuse the cord. Never use the cord for carrying, pulling or unplugging
the power tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
• When operating a power tool out-doors, use an extension cord suitable
for outdoor use. Use of a cord suitable for outdoor use reduces the risk
of electric shock.
• If operating a power tool in a damp location is unavoidable, use a residual
current device (RCD) protected supply. Use of an RCD reduces the risk
of electric shock.
3.3. POWER TOOL USE SAFETY
• Do not over load the tool, select suitable tool to work make you safe and
high efficiency.
• Do not use the tool if the switch doesn't work properly. Tool should be
repaired if the switch doesn't work.
• Disconnect the battery from the tool before adjusting, repair, replace or
storage the tool. This will avoid injuries due to unexpected start of the tool.
• Store the tool away from the children, do not put tool to non-training
person operate.
• Maintain tools. Always check tool, moving parts, any damage parts are
all can cause injury, the correct maintenance of the tool can avoid injury.
• Keep blade sharp and clean. Sharp and clean blade can be easily
controlled and not jams.
• Read manual before using the tool, select suitable tools and right
accessories to avoid injury.
www.kamikazevolpi.com
35