Troubleshooting - Husqvarna 350BT Manuel D'utilisation

4. Clean the air filter with warm water with soap.
Note:
An air filter that has been used for a long
time cannot be fully cleaned. Replace the air filter
regularly and always replace a defective air filter.
5. Clean the inner surface of the air filter cover (A) with
a brush.
6. Apply oil to the air filter. Refer to
foam air filter on page 12 .
7. Put the air filter in the filter frame.
8. Attach the air filter cover to the product.
To apply oil to the foam air filter
CAUTION:
special air filter oil. Do not use other types of
oil.
WARNING:
The air filter oil can cause skin irritation.
1. Put the foam air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the foam air filter.
4. Push the unwanted oil out of the foam air filter while
in the plastic bag.
The engine is not possible to start
Check Possible cause
Stop button. Stop position
Starter pawl/s. Blocked or
worn starter
pawl/s.
12
To apply oil to the
Always use Husqvarna
Put on protective gloves.

Troubleshooting

Solution
Set the stop switch to the start position.
Adjust or replace the starter pawl/s.
Clean around the starter pawl/s.
Speak to an approved servicing dealer.
To replace the harness
WARNING:
make the product fall and cause injuries.
Make sure to install the clamp correctly.
1. Stop the engine.
2. Remove the clamp from the strap.
3. Push the end of the strap through the eyelet.
4. Pull the new strap through the eyelet.
5. Put the pin into the strap to attach the clamp to the
new strap.
A damaged harness can
1246 - 004 - 18.10.2021