Undertray / Plate Holder / Rear Hugger; Belly Pan / Low Fairing / Scoop By Air / Seat Cover - Ermax KBA 31110 Guide De L'utilisateur

WARNINGS ABOUT USE AND FITTING

UNDERTRAY / PLATE HOLDER / REAR HUGGER

- In order to respect legal requirements, it is necessary to fol-
low fitting rules about light systems and signs, and plate num-
ber. Please refer to directives in application in your country.
- It is advised to check the slope of the number plate before assem-
bly, and if necessary, fold the plate metal support so as to preserve
a slope in the standards (do not fold the metal support while fixed
on the ABS part)
- Any deterioration of the undertrays or plate holders due to the
presence of any excessive load will not be guaranteed.
- A few tyres, faithful to ETRTO standards, may be in fact bigger and
higher than dimensions engraved on the tyre (until + 10 mm). They
may be not compatible with undertrays and rear huggers which
we made with original tyres and whose dimensions correspond
to these ones engraved on tyre.
- It is necessary to harden the rear shock absorber while driving with
load or on dented roads.
BELLY PAN / LOW FAIRING / SCOOP BY AIR / SEAT COVERS
- Move hoses so that they do not fall inside the belly pans or low fai-
rings
(especially gasoline and oil flowing hoses of 600 Hornet 2003/2013)
deterioration due to flows of corrosive products is not guaranteed.
- Belly pans and low fairings will be neither retaken nor exchanged
in case of rubbing during a "sports" driving, or during the clearing of
pavements, uneven road surfaces ... The fitting of Ermax accesso-
ries is planned for a normal road use.
OF «ABS» PARTS
(part provided with a few undertrays and plate holders)
www.ermax.com - accueil@ermax.fr
English
.
. Any
09