Publicité
Les langues disponibles
Les langues disponibles
With the saw chain running, saw into the wood, using the
top handle to raise the saw and the front one to guide it.
Use the serrated rail as a pivot.
Continue the cut by applying slight pressure to the front
handle, easing the saw back slightly. Move the serrated
rail further down the timber and raise the front handle
again.
When making several cuts, switch the chain saw off
between cuts.
006914
CAUTION:
If the upper edge of the bar is used for cutting, the
•
chain saw may be deflected in your direction if the
chain becomes trapped. For this reason, cut with
the lower edge, so that the saw will be deflected
away from your body.
A
B
B
A
006915
Cut wood under tension on the pressure side (A) first.
Then make the final cut on the tension side (B). This
prevents the bar from becoming trapped.
Limbing
CAUTION:
Limbing may only be performed by trained persons.
•
A hazard is presented by the risk of kick-back.
When limbing, support the chain saw on the trunk if
possible. Do not cut with the tip of the bar, as this
presents a risk of kickback.
Pay particular attention to branches under tension. Do
not cut unsupported branches from below.
Do not stand on the felled trunk when limbing.
Burrowing and parallel-to-grain cuts
CAUTION:
Burrowing and parallel-to-grain cuts may only be
•
carried out by persons with special training. The
possibility of kickback presents a risk of injury.
010942
Perform parallel-to-grain cuts at as shallow an angle as
possible. Carry out the cut as carefully as possible, as
the serrated rail cannot be used.
Felling
CAUTION:
Felling work may only be performed by trained
•
persons. The work is hazardous.
Observe local regulations if you wish to fell a tree.
2
1
/
2
1
006917
−
Before starting felling work, ensure that:
(1)
Only persons involved in the felling operation
are in the vicinity;
(2)
Any person involved has an unhindered path
of retreat through a range of approximately
45 ° either side of the felling axis. Consider
the additional risk of tripping over electrical
cables;
(3) The base of the trunk is free of foreign objects,
roots and ranches;
(4)
No persons or objects are present over a
distance of 2 1/2 tree lengths in the direction
in which the tree will fall.
−
Consider the following with respect to each tree:
Direction of lean;
•
Loose or dry branches;
•
Height of the tree;
•
Natural overhang;
•
Whether or not the tree is rotten.
•
−
Consider the wind speed and direction. Do not
carry out felling work if the wind is gusting strongly.
−
Trimming of root swellings: Begin with the largest
swellings. Make the vertical cut first, then the
horizontal cut.
13
1. Felling area
45
o
45
o
Publicité
