Publicité
Les langues disponibles
Les langues disponibles
CAUTION: VOLTAGE INCOMPATIBILITY BETWEEN THE EMERGENCY STARTER AND THE
VOLTAGE OF THE VEHICLE'S ELECTRICAL SYSTEM CAN CAUSE EXPLOSIONS AND
DAMAGE THE VEHICLE, PRODUCT AND PEOPLE.
4. .Be sure that the Battery Clips are disconnected. ATTENTION: If the Battery Clips are
connected, the "Err8" error, will showed.
5. Now PRESS "START/STOP", the display show "SET"
6. Select the correct tension, 12V or 24V, using the selection button
7. Set "MEMORY SAVER" function.
8. Now PRESS "START/STOP" for 3 seconds, until "ON" blink on the display.
9. Release the button and the display show "MEMO"
10. Connect the Battery Clips and perform the Memory Saver activities.
11. Identify the pole corresponding to the earth of the vehicle; this is generally connected to the
negative terminal.
12. CAUTION: never switch polarity. Always connect the output conductor with a red battery
clip (+) to the positive pole of the battery and the output conductor with a black battery clip (-)
to the vehicle's earth (ground). CAUTION: INVERTING POLARITY CAN CAUSE EXPLOSIONS,
DAMAGE THE VEHICLE, PRODUCT AND PEOPLE.
CAUTION: if the LED RED / REVERSE is set on, the polarity has been reversed. Disconnect the
battery clips from the vehicle and connect them correctly.
CAUTION: check that the cables of the Emergency Starter are far away from fans, from moving parts
and from the fuel conduit.
13. Once the activities are completed, press START/STOP button to turn off the emergency starter .
14. Disconnect the output conductor with the black battery clip from the earth of the vehicle and
replace output conductor with the black battery clip in its housing.
15. Disconnect the output conductor with the red battery clip from the positive terminal (+) of the
battery and return it immediately to its seat.
CAUTION Always recharge the Emergency Starter after each time that it is used.
ERROR WARNINGS:
Err 1
REVERSE/SHORTCIRCUIT/DAMAGED BATTERY
Err 2
WRONG TENSION
Err 3
HIGH TEMPERATURE OF INTERNAL BATTERY
Err 4
DISCHARGE INTERNAL LITHIUM BATTERIES
Err 5
--------------
Err 6
OVER LOAD (START FUNCTION)
Err 7
OVER LOAD (MEMORY SAVER FUNCTION)
WRONG PROCEDURE IN "OVER RIDE" OR "MEMORY SAVER" FUNCTION
Err 8
Err 9
DEMAGED INTERNAL FUSES
Publicité
