Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9. Place a level on top of the All-In-One Washer and Dryer and
ensure that it is level from front to back and side to side.
10. Adjust the feet so that the rubber pads extend just below
the bottom of the pedestal and keep the pedestal at least
1/8" (3.175 mm) off the floor.
NOTE: For more stability, do not raise the bottom of the
pedestal any higher than necessary to clear the floor on
all four sides.
To adjust the All-In-One Washer and Dryer feet:
Use a 11/16" (17 mm) open-end wrench to loosen the
n
locknut.
Adjust the All-In-One Washer and Dryer feet up or down.
n
Be sure to completely tighten the locknuts again after
the All-In-One Washer and Dryer is level.
11. Follow the Installation Instructions that came with your
model to finish installing or reinstalling your All-In-One
Washer and Dryer.
4
Publicité
Table des Matières
