Safety Information; Lighting The Stove - ROBENS 690114 Mode D'emploi

I N S T R U C T I O N M A N U A L I N S T R U C T I O N M A N U A L
I N S T R U C T I O N M A N U A L I N S T R U C T I O N M A N U A L
2
INTRODUCTION:
Category: Vapour direct pressure
Gas cartridge: This appliance shall only be used with
Butane-Propane mix gas cartridge (FIRE-MAPLE, FMS-G1
230g) complying to EN417. It may be hazardous to attempt
to fit other types of gas cartridges or gas cylinders
Nominal rate: 251 g/h 3.47kW
Injector: 0.32 mm
USE OUTDOORS ONLY

SAFETY INFORMATION:

Check that seals (between the appliance and the gas
cartridge (6.)) are in place and in good condition before
connecting to the gas cartridge.
Do not use the appliance if it has damaged or worn seals
Do not use an appliance which is leaking. damaged or
which does not operate properly.
Operate only on a horizontal, non-flammable, surface.
Keep away from all flammable materials. Keep a 1.0 meter
distance to flammable materials to all sides.
Gas cartridge shall be changed in a well ventilated location,
preferably outside, away from any sources of ignition, such as
naked flames, pilots, electric fires and away from other people.
If there is a leak on your appliance (smell of gas), take
it outside immediately into a well-ventilated flame free
location where the leak may be detected and stopped. If
you wish to check for leaks on your appliance, do it outside.
Do not try to detect leaks using a flame, use soapy water.
INFORMATION FOR ASSEMBLY AND USE:
Do not leave a fully assembled gas stove unsupervised
– especially when lit or cooling. Keep it out of reach of children.
Do not touch the hot burner when in use or after use.
Disconnect the gas stove from the gas cartridge, when
storing the stove. Let the stove cool, before storing it.

LIGHTING THE STOVE:

1. Unfold the pot supports (2.).
2. Completely close the gas feed by turning the flame
control knob (4.) to the right (clockwise) to OFF position.
3. Remove the protective plastic cap from the gas cartridge
and carefully screw the cartridge on the gas valve
(5.). – care should be taken for a little gas will be lost
to the atmosphere at this point. Do not overtighten for
this may damage the stove's dual leak-proof gasket that
prevents leakage.
4. Turn the flame control knob (4.) to the left (counter-
clockwise) twice. Place a naked flame around 1-3cm
from the burner and the gas should ignite immediately.
5. A normal flame should be stable and burn upward with a
blue or saffron yellow colour depending on flame control.
Turn the flame control knob (4.) clockwise to reduce the
flame, turn the knob counter-clockwise to increase the flame.
If you experience flaring (high yellow flames), eq. if moving
the stove while lit, turn down the flame and wait a few
seconds. Slowly adjust the flame up again to the desired
level.
Avoid twisting the flexible hose.
Regularly inspect the integrated gas seal for damage.
Apply warm soapy water at the joint and junction of the
equipment to highlight leaks through the formation of
bubbles. If you hear or smell gas don't attempt to ignite the
appliance if you can hear or smell leaking gas. If you smell
gas: Do not attempt to ignite equipment; Put out all flames;
Disconnect fuel supply.