Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Measure the distance between the side walls of the cabinet.
They should measure 22
greater than 22" + 1/16" (55.9 cm + 0.07 cm), the bracket
spacers will need to be used. Four 1 mm bracket spacers are
included. See Step 2.
2. If bracket spacers are needed: Position the necessary
spacer(s) behind the mounting brackets. Continue with
Step 3.
A
A. Bracket spacers
3. Determine where the mounting brackets will be installed and
with the mounting brackets (and spacers) held or taped in
place, mark 6 holes through each mounting bracket onto the
side cabinet.
IMPORTANT: The front of the mounting bracket must be
1/16" (2 mm) from the front fascia thickness of the cabinet
frame.
NOTE: To accommodate for flush installation with 3/4"
(1.9 cm) custom cabinets, align the front of the mounting
brackets 13/16" (2.1 cm) back from the front of the flush
surface.
A
B
B
A. Front of mounting bracket 1/16" (2 mm)
from outside of cabinet frame
B. Mark 6 screw holes.
INSTALLATION INSTRUCTIONS
Install the Mounting Brackets
/
" (55.97 cm). If the distance is
1
16
A
4. Using a 1/16" (2 mm) drill, drill the holes marked in Step 3.
5. Secure the mounting brackets to the side cabinets with six
3/16" x 5/8" (4.5 x 16 mm) screws in each bracket.
6. Remove the tape holding the brackets in place.
7. Pull the runners forward until they are fully extended and in
the locked position. Place level across the runners and check
levelness. Then place the level along the length of each
runner and check levelness from front to back. If the runners
are not level, uninstall the mounting brackets and raise or
lower the mounting brackets as necessary until they are
level.
NOTE: If the runners are not level, uninstall the mounting
brackets and raise the mounting brackets as necessary
using the metal shims provided, until they are level.
x 4
8. If the coffee system is being installed above a wooden
cabinet bottom, use two 3/16" x 5/8" (4.5 x 16 mm) screws
to install the metal trim piece at the front edge of the cabinet
bottom.
A. Metal trim piece
A
5
Publicité
Table des Matières
