Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Determine where the mounting brackets will be installed and
mark 6 holes through each mounting bracket onto the side
cabinet.
IMPORTANT: The front of the mounting bracket must be
1/16" (2 mm) from the outside of the cabinet frame.
NOTE: To accommodate for flush installation with certain
custom cabinets, align the front of the mounting brackets
13/16" (2.1 cm) back from the front of the cabinet.
A
B
B
A. Front of mounting bracket 1/16" (2 mm)
from outside of cabinet frame
B. Mark 6 screw holes.
2. With the mounting brackets held or taped in place,
measure the distance between the two brackets. (Do not
measure between the runners.) The distance should be
21¹¹⁄zn" (55.1 cm).
NOTE: If the distance between the mounting brackets is
greater than 22" + 1⁄16" (55.9 + 0.07 cm), bracket spacers
will need to be used. Four 1 mm bracket spacers are
included. See Step 3.
3. If bracket spacers are needed: Position the necessary
spacer(s) behind the mounting brackets. Continue with
Step 4.
A
A. Bracket spacers
INSTALLATION INSTRUCTIONS
Install the Mounting Brackets
A
4. Using a 1/16" (2 mm) drill, drill the holes marked in Step 1.
5. Secure the mounting brackets to the side cabinets with six
3/16" x 5/8" (4.5 x 16 mm) screws in each bracket.
6. Remove the tape holding the brackets in place.
7. Pull the runners forward until they are fully extended and in
the locked position. Place level across the runners and check
levelness. Then place the level along the length of each
runner and check levelness from front to back. If the runners
are not level, uninstall the mounting brackets and raise or
lower the mounting brackets as necessary until they are
level.
8. If the coffee system is being installed above a wooden
cabinet bottom, use two 3/16" x 5/8" (4.5 x 16 mm) screws
to install the metal trim piece at the front edge of the cabinet
bottom.
5
Publicité
Table des Matières
