Publicité
Les langues disponibles
Les langues disponibles
Performing Measurement
a. For temperature measurements,the display shows the present environment temperature directly.
b. For moisture measurements, Take off probe shield and press the pins of two sides with fingers , Insert the
pins into the object approx. 5mm, which display the containing water of the object.
Automatic Power-Off Feature
If you don't operate the instrument (or the reading does not change)for about 5 minutes,the instrument will turn
off automatically.
Data Hold
a. Only the moisture measurement status, press the HOLD key to lock the measured values
b.
For temperature measurements, press the HOLD key to be useless.
LED indications for moisture and related settings
a. This apparatus can indicate the moisture of the objects to be measured through the lighting of the color LED.
There are two values for controlling the warning of LED light, namely AL1 and AL2. The factory defaults of wood
moisture are: AL1=13, AL2=18, and for Material moisture, they are: AL1=0.3, AL2=0.8, If the measured value is less
than 13, the green indicator will be turned on. If it is higherthan 18, the red indicator will be turned on. If it is
between 13 and 18, the yellow indicator will be turned on. The user can set these two values in light ofhis own
conditions
b. Set the warning value
(1)
To set the value of AL1, press the "SELECT" button and hold it till "AL1" appears(it takes about 3 seconds),
T he use "hold ▲" or "℃/℉ ▼" to change the number to the value you desire. To exit the seting mode,press
"select" again.
(2) To set the value of AL2, press the "SELECT" button and hold it till "AL2" appears(it takes about 5
seconds), to change the number, Ditto operation.
NOTE
1. Keep the instrument dry.
2. Keep the probe clean.
3. Keep the instrument and battery out of reach of infant and child.
4. Some factors (such as material type and temperature can affect moisture measurement result and
may make it necessary to correct the displayed value.Don't use the instrument in the case of inspections
or for reference purposes.
5. When the symbol " "
Ensure that battery polarity connections are correct when replacing batteries.
If you will not use the instrument for a long period,remove the batteries.
DECLARATION
1. This users manual is subject to change without notice.
2. Our company will not take the other responsibilities for any loss.
3. The content of this manual can not be used as the reason to use the meter for any special application.
DISPOSAL OF THIS ARTICLE
Dear Customer,
If you at some point intend to dispose of this article,then please keep in mind that
many of its components consist of valuable materials,which can be recycled.
Please do not discharge it in the garbage bin,bucheck with your local council
for recycling facilities in your area.
Above picture and content just for your reference. Please
be subject to the actual products if anything different or
updated. Please pardon for not informing in advance.
as - Schwabe GmbH · Hummelbergstr. 6 · 72184 Eutingen · www.as-schwabe.de
" appears,the batteries are low and should be replaced.
.
Publicité
