HAIRCUT PROFESSIONAL TH37 Manuel D'utilisation page 19

SERVICING
R
OUTINE SERVICING
◼ After 30 minutes of use, it is advisable to lubricate the blades. Use the lubricating
oil supplied with the equipment (Fig. 1-L).
◼ Lubricate the blades at least once a day (Fig. 4).
◼ After using the equipment each time, clean the blades with the brush supplied
(Fig. 1-M).
◼ If necessary, clean the body of the equipment with a cloth slightly moistened
with water or mild liquid soap. Never use abrasive products or solvents.
◼ Clean the blades with an antibacterial spray. We recommend the STERIL
CLEANER 920- cleaning, lubricating and cooling product.
C
LEANING THE BLADES
In the case of intensive use, clean the blades at least once a day.
◼ Remove the blades as described in § 3.4.
◼ Clean the inside of the blades with the brush supplied (Fig. 1-M).
◼ Lubricate the cutters (Fig. 3) and put the blades back on the equipment as
described in § 3.4.
Copyright © 2019 by C.A.R. SAS
Document code: TH37-DOC – English version
Edition September 2020 – Version 1
All rights reserved. Reproduction of all or part of this document, in any form
whatsoever, is prohibited unless C.A.R. SAS has given its prior written
approval thereto.
Due to ongoing research and development, the specifications of this product
may be modified at any time without notice.
To the best of our knowledge, the information in this manual is accurate.
Photos are not contractually binding.
19