HAIRCUT PROFESSIONAL TH37 Manuel D'utilisation page 18

USE
S /
WITCHING ON
When first used, lubricate the blades by applying a drop of oil to the points
shown (Fig. 3).
◼ Connect the power cord (Fig. 1-E) to a mains power socket.
◼ Switch the clippers on by pressing the On/Off switch (Fig. 1-B).
◼ After use, stop the clippers and disconnect the electrical lead.
A
DJUSTING THE CUTTING HEIGHT WITH THE LEVER
The cutting height can be adjusted during use of the equipment, with the adjusting
lever (Fig. 1-C):
◼ Push the lever upwards to reduce the cutting height.
◼ Push the lever downwards to increase the cutting height.
U
SING THE COMB ATTACHMENTS
◼ The equipment must be switched off. Select a comb attachment
(Fig. 1 refs. F-K).
◼ Place the comb attachment on the blades and clip in at the rear. When the comb
attachment is correctly fixed, it is immobilized.
R
EPLACING BLADES
◼ Switch the equipment off and unplug the unit from the mains power supply.
◼ Take the screws out of the blades (Fig. 2) and remove the upper and lower
cutters.
During their assembly, the upper and lower cutters must be aligned as instructed
below:
◼ Set the adjusting lever to the minimum cutting height.
◼ The distance between the front edge of the lower cutter and the front edge of
the upper cutter must be between 0.8 mm and 1.5 mm.
◼ The upper and lower cutters must be set parallel.
◼ The end tooth on the upper cutter (on the left-hand end) must cover the end
tooth on the lower cutter.
◼ The other end tooth on the upper cutter (on the right-hand end) must also touch
the corresponding end tooth on the lower cutter (on the right-hand end).
◼ Tighten the two screws (Fig. 2).
OFF
18