Important - Herth+Buss ELPARTS Notice D'emploi

Bedienhinweis
Produktfamilie
DE
Montageanleitung für Blitz-Kennleuchte
Aufsteckrohr Verlängerunge
www.herthundbuss.com
84770004 I -006
Stromanschluss
Rot
Schwarz
Grün Gelb
Zubehör
Stecker für Stecker Saugknöpfe
Zigarrettenanzünder
Weiteres Zubehör
Geneigte Gummidichtung Dichtung
Operating Instruction
Installation of the light
On plug (Fig. 1)
version „FLEX" , „LINE" and „ELAST"
1. Mount the socket pipe on the vehicle
body Ⓐ and attach the light.
2. Place the light on the socket pipe by turning
the pin clockwise.
With screws (Fig. 2)
version „PLANE"
The light must be bolted to a surface running
parallel to the road level.
1. To route the connecting cable, drill a
corresponding hole at the installation
site, insert a rubber bushing Ⓑ into
the hole and connect the cables to the
power system.
2. Use 3 holes with ø 6.5 mm a 120° to ø 130
mm. To mark the drill holes, use the lower
Blau
part of the light as a template. Screw on the
light with 3 M6 screws.

IMPORTANT

Read carefully before use
Keep for later reference
The latest version of the Operating/
Fitting instructions is also available
in our online catalogue:
herthundbuss.com/online catalogue
4
5
84770004 I -006
On a magnetic base (Fig. 3) version „PLANE
MAGNETICO"
1. Secure the magnets Ⓒ on the base Ⓓ
with the 4.8 mm screw Ⓔ in the space on
the base Ⓓ.
2. Fix the suction pads:
a. Insert the suction pads Ⓕ in the 3
slots on the base Ⓓ . (Fig. 3a).
b. Fix the magnets Ⓒ together with
the suction pads Ⓖ using the same
screws (4.8 mm) Ⓔ (Fig. 3b).
Version „PLANE MAGNETICO"
and „MAGNETICO"
3. To start up the light, plug the plug Ⓗ into
the cigarette lighter socket with the inter-
mediate pipe Ⓘ.
Technical data:
EN