Schulter Systems KERDI-BOARD-NLT Mode D'emploi page 64

Attaching the sealing collar
Personnel
Protective equipment
For installation in wet areas, glue the joints around the outer flange with the addition of Schlüter
KERDI-COLL-L. Use the KERDI sealing collar included in the delivery to this end.
1. Ensure that the niche is durably connected to the installation location.
2. Ensure that all connecting elements are flush with the niche surface.
3. Place the sealing collar in such a way that the circumferential joint on both sides overlaps
by approx. 5 cm. In doing so, ensure that the sealing collar is glued parallel to the circum-
ferential joint with Schlüter
> The circumferential joint is completely covered by the sealing collar. The sealing collar
overlaps by approx. 5 cm on both sides of the joint.
64
Tiler
Protective gloves
KERDI-COLL-L.
®-
-
®