Belkin OmniView Quad-Bus Module d'interface serveur, PS/2 Guide D'installation Rapide page 8

Step 5
Connect the Quad-Bus KVM-over-IP or CAT5 KVM Switch to the
Server Interface Module using the included Belkin CAT5e Patch Cable
or other CAT5 cable.
Step 6
Repeat steps 2 through 5 for each additional PS/2 server you wish
to connect.
Step 7
Power up all connected servers.
Step 8
Power up your Quad-Bus KVM-over-IP or CAT5 KVM Switch.
You are now ready to use your OmniView Quad-Bus Server Interface Module.
If you have any problems during installation, please refer to the OmniView
Quad-Bus KVM-over-IP or CAT5 KVM Switch User Manual.
Installing your Server Interface Module
8
P58380ea_F1DW101AeaAP-8P.indb 8
Server
10/1/07 9:33:37 am